IDC11375I THESE ADDITIONAL VVDS REFERENCED CATALOGS WERE ENCOUNTERED

Explanation
The catalog names listed are referenced by VVDS
entries but these names were not found as catalog entries in the VVDS.
The VVDS contains the names of all referenced catalogs in the VVDS
control record (VVCR). Each entry in the VVDS contains the name of
the catalog in which the component is cataloged. There were catalog
names in VVDS entries which were not also in the VVCR.
This
message applies only for volumes and catalogs with non-SMS-managed
data sets.

System action
 Consider this an attention condition, processing
continues.

Programmer response
This message is an attention and may signal
entries which are missing or damaged. Either the VVCR entry for the
catalog is missing, or a VVDS record is referring to a catalog incorrectly.
Run DIAGNOSE ICFCATALOG against each catalog listed, and compare each
to the VVDS.
To add the catalog name to the VVCR, define a dummy
data set on the volume by using the DEFINE command, and specify the
catalog name needed in the CATALOG parameter. Then delete the dummy
data set by using the DELETE command. The catalog name remains in
the VVDS control record because a VVDS entry refers to the catalog.
To
remove the VVDS entry, if the reference to the catalog is the result
of an extraneous VVDS entry, use the DELETE VVR command.

Source
DFSMSdfp

Module
IDCDA03