IDC2053I STEP CONTAINS JOBCAT/STEPCAT, BUT JOBCAT/STEPCAT SUPPORT IS DISABLED

Explanation
A step that referenced a data set
contains one of the following: a JOBCAT DD statement
a STEPCAT DD statement
both a JOBCAT and a STEPCAT DD statement

but the use of JOBCAT and STEPCAT is disabled by the installation

System action
The indicated command is terminated.

Programmer response
Depending on the DD statements
present in the step, take one of the following corrective actions: Remove the JOBCAT DD statement if there is no need for it.
Remove the STEPCAT DD statement if there is no need for it.
Ensure that all referenced catalogs are connected to the system
master catalog with an appropriate alias for the data set being referenced
and allow the data set to be found through a standard search.

If the actions above cannot be performed, the use of JOBCAT and
STEPCAT support can be enabled by the installation through the operator
command MODIFY CATALOG,ENABLE(JOBSTEPCAT). It is not recommended this
facility be enabled except when absolutely needed.

Source
DFSMSdfp

Module
IDCTP06