ICU030I CRYPTOGRAPHY INITIALIZATION UNABLE TO LOCATE name IN LPA
Explanation
The Cryptographic Unit Support installation process invoked by the operator START command or the key generator utility program was unable to locate the routine specified by name in a search of the active link pack area queue and the link pack area directory.
System action
Cryptographic Unit Support initialization processing ends.
Operator response
Notify the system programmer.
System programmer response
Determine if the GENKEY or RETKEY installation exit routine (module ICUMGR90 or ICUMGR95) is properly link edited into SYS1.LPALIB. If the module has been replaced since the Cryptographic Unit Support was installed, check the linkage editor output from the most recent change. If it has not been replaced, check the output of the install process (SMP) to see that the module was properly installed. Correct the problem and reissue the operator START command or rerun the key generator utility program.
To ensure that you have all the messages issued for this problem, specify MSGLEVEL=(1,1) for the job.
Source
Cryptographic Unit Support Program (CUSP)
Routing code
10,11,*
Descriptor code
4