ICT1032 CRYPTOGRAPHY EMK FUNCTION FAILED - CODE xx
Explanation
An error occurred during the processing of an EMK
macro instruction issued by the key generator utility program. In
the message text, xx is the error return code from
the EMK macro. The values of xx and their explanations
are as follows:
- Code
- Explanation
- 4
- The Programmed Cryptographic Facility has not been initialized.
- 8
- The operation requested was not valid; the macro was not EMK.
- 12
- An ESTAE recovery environment could not be established.
- 32
- The address of the clear key-encrypting key or the address of the enciphered key-encrypting key was specified as zero.
System action
Key generator utility processing ends.
Programmer response
Contact your programming support personnel. When the problem has been corrected, rerun the key generator utility program as follows. If the SETM or CHGM function was requested and the host master key was not set, (message ICT010I was not issued), rerun the entire job. Otherwise, use this listing to determine which control statements were processed successfully. Then rerun the utility program using the CHGK function to process the remaining control statements.
To ensure that you have all the messages issued for this problem, specify MSGLEVEL=(1,1) for the job.
Source
Programmed Cryptographic Facility (PCF)
Module
ICTMKG00, ICTMKG01