ICT030I CRYPTOGRAPHY INITIALIZATION UNABLE TO LOCATE `name` in LPA

Explanation
The Programmed Cryptographic Facility installation
process invoked by the operator START command or the key generator
utility program was unable to locate the routine specified by name
in a search of the active link pack area queue and the link pack area
directory.

System action
Programmed Cryptographic Facility initialization
processing ends.

Operator response
Notify the system programmer.

Programmer response
Determine if the GENKEY or RETKEY installation
exit routine (module ICTMGR90 or ICTMGR95) is properly link edited
into SYS1.LPALIB. If the module has been replaced since the Programmed
Cryptographic Facility was installed, check the linkage editor output
from the most recent change. If it has not been replaced, check the
output of the install process (SMP or SYSGEN) to see that the module
was properly installed.  Correct the problem and reissue the operator
START command or rerun the key generator utility program.
To
ensure that you have all the messages issued for this problem, specify
MSGLEVEL=(1,1) for the job.

Source
Programmed Cryptographic Facility (PCF)

Routing code
*,10,11

Descriptor code
4

ICT030I CRYPTOGRAPHY INITIALIZATION UNABLE TO LOCATE name in LPA

Explanation

System action

Operator response

Programmer response

Source

Routing code

Descriptor code

ICT030I CRYPTOGRAPHY INITIALIZATION UNABLE TO LOCATE `name` in LPA