IEA498I dev,volser,PPRC-PATH variable-text SSID=ssid (PRI)=aaaa-bbbbb,CCA=cc optional-text SENSE=sense
Explanation
When one or more paths between peer subsystems are removed or established for any reason other than online execution of Establish Peer-to-Peer Remote Copy Paths order or Remove Peer-to-Peer Remote Copy Paths order, a unit check is generated to detect this action. This message is issued to alert the operator of the action so appropriate action is taken.
In the message text:
- dev
- The device number of the primary device of a PPRC pair.
- volser
- The volume serial number of the primary device of a PPRC pair.
- variable-text
- One of the following:
- ONE OR MORE PPRC PATHS REMOVED UNEXPECTEDLY
- ONE OR MORE PPRC PATHS RESTORED
- ALL PPRC PATHS REMOVED UNEXPECTEDLY
- ONE OR MORE PPRC PATHS REMOVED BY CUIR
- ALL PPRC PATHS REMOVED BY CUIR
- ONE OR MORE PPRC PATHS ARE DEGRADED
- ONE OR MORE PPRC PATHS ARE NO LONGER DEGRADED
- ssid
- The ssid of the device in error.
- aaaa-bbbbb
- This is the primary PPRC volume storage control serial number.
The reported serial number can be one of the following:
- aaaa — The first four bytes of the storage control serial number.
- bbbbb — The last five bytes of the 12-byte sequence number portion of the serial number. This number can be found on the lower left-hand portion of the storage control operator panel.
- cc
- The primary volume’s channel connection address.
- optional-text
- CONTINUATION OF IEA498I SNS=senseIn the message text:
- The sense data if present for the device error.
- sense
- The 32 characters of sense data reported by the device.
xxxx xxxx xxxx xxxx xxxx xxxx xxxx xxxx
System action
If other paths between peer subsystems are available performance can be affected by the loss or addition of this path. If the last path between peer subsystems is removed, an IEA491E message will most likely be generated and PPRC operation is suspended.
Operator response
Follow your installation's procedures for reporting this error.
Source
DFSMSDFP
Module
IGGSNS01