IEA793A NO SVC DUMP DATA SETS AVAILABLE FOR DUMPID=dumpid FOR JOB (*MASTER*). USE THE DUMPDS COMMAND OR REPLY D TO DELETE THE CAPTURED DUMP
Explanation
The system has captured the data for the dump but cannot locate an available dump data set for the dump. An available dump data set is either a SYS1.DUMPnn data set with the first record containing an end of file, or an automatically allocated data set. If automatic dump data set allocation is already active, check the syslog for a previous IEA799I message for details about the dump data set allocation failure.
In the message text:
- dumpid
- A 3-character dump identifier.
System action
SVC dump processing continues to search for an
available dump data set until one of the following occurs:
- An available dump data set is found
- The operator replies D to delete the captured dump
- The interval specified by the MSGTIME parameter on the CHNGDUMP command expires
Operator response
Do one of the following:
- Use the DUMPID on the DISPLAY DUMP command to display the title or error information.
- Enter the DUMPDS command to clear an existing dump data set or to add a new dump data set in order to write the dump to a data set.
- Reply D to the message. SDUMP will delete the captured dump.
- Run a utility to clear an existing dump data set.
- Add additional SMS classes (DUMPDS ADD,SMS=) or DASD volumes (DMPDS ADD,VOL=) to the automatic allocation facility, or correct the problem which caused the automatic dump data set allocation failure.
If a utility other than DUMPDS is used to make a dump data set available automatically, no response is required. SVC dump processing periodically searches the queue of data sets until one becomes available or the MSGTIME interval expires.
Source
SVC dump
Module
IEAVTSCD
Routing code
1
Descriptor code
2