IDC31562I THE parameter PARAMETER IS NOT AVAILABLE FOR THE SPECIFIED SUBSYSTEM OR DEVICE
Explanation
A LISTDATA or SETCACHE command was issued. Either
a parameter that is not supported on the device specified was encountered
or a hardware error might have caused the device to be unable to perform
the requested command. This message is also printed if:
- The device specified for a duplex pair secondary or alternate device is not attached to a 3990 Model 3 or Model 6.
- DIRECTOR (SD) is requested for a device not attached to a 3880 Model 21.
- SETCACHE REINITIALIZE, SETCACHE SUBSYSTEM OFF, SETCACHE NVS OFF, or LISTDATA ACCESSCODE is issued to the secondary device of a duplex pair.
- DUAL COPY OPERATION (SETSECONDARY, SUSPENDPRIMARY, SUSPENDSECONDARY, RESETTODUPLEX, REESTABLISHDUPLEX, RESETTOSIMPLEX) was issued to a 2105 storage control unit.
In the message text:
- parameter
- The parameter that is not applicable for the specified subsystem. For SETCACHE, unsupported parameters include:
- CACHEFASTWRITE
- DASDFASTWRITE
- DESTAGE
- DIRECTOR
- DISCARDPINNED
- NVS
- PENDINGOFF
- REESTABLISHDUPLEX
- REINITIALIZE
- RESETTODUPLEX
- RESETTOSIMPLEX
- SETSECONDARY
- SUSPENDPRIMARY
- SUSPENDSECONDARY
- UNITNUMBER
- DEVICE
- SUBSYSTEM
For LISTDATA, unsupported parameters include:- DSTATUS
- PINNED
- ACCESSCODE
System action
Processing continues.
Programmer response
Resubmit the job, specifying the appropriate device. Check the status of the device to verify that it can perform the requested command.
Source
DFSMSdfp
Module
IDCSS01