Syntax
The complete syntax for the HALT command is:
|
The HALT EOD command causes the system to take the following steps:
- Store the internal I/O device error counts in the logrec data set.
- Empty the SMF buffers onto the active SMF data set in SYS1.MANx.
- Switch to another SMF data set in SYS1.MANx, allowing the previously active SMF data set to be dumped according to your installation's procedures.
- Close the system log and put it on the print queue.
When these actions are completed, the system sends you the message:
IEE334I HALT EOD SUCCESSFUL.
For more information about SMF HALT processing, see z/OS MVS System Management Facilities (SMF).