Displaying SLIP trap information
Use the DISPLAY SLIP command to display information about SLIP
traps.
|
- SLIP
- Indicates that the system is to display summary information about SLIP traps or detailed information about one SLIP trap (message IEE735I).
- xxxx
- The system is to display detailed information about the SLIP trap
associated with the identifier xxxx. If you do
not specify xxxx, the system lists all the SLIP
traps in the system and tells whether each trap is enabled or disabled.
Where asterisks replace any or all of the four characters of xxxx, the system displays all SLIP traps whose identifiers match the non-asterisk characters in xxxx. If you specify fewer than four characters, the xxxx is padded on the right with blanks. A matching identifier must have blanks in those positions.
The asterisks allow you to group your SLIP traps by common characters and display them as a group.
- PER
- This will display the names of the PER traps (or a suitable message
if there are none), indicating for each whether it is:
- DISABLED
- ENABLED but IGNORE
- ENABLED and non-IGNORE
- ENIPT
- This will display the name of the enabled non-ignore PER trap if there is one, and a suitable message if there is not.
- L=a, name, or name-a
- Specifies the display area (a), console name
(name), or both (name-a) where
the display is to appear.
If you omit this operand, the display is presented in the first available display area or the message area of the console through which you enter the command.
Example 1:
To display all SLIP traps and whether they are enabled or disabled,
enter:
DISPLAY SLIP
Example 2:
To display detailed information about trap W292, enter:
D SLIP=W292
Example 3:
To display all SLIP traps with an identifier having ‘A’ as the
first character and ‘B’ as the third character and identify whether
they are disabled or enabled, enter:
DISPLAY SLIP=A*B*
Example 4:
To display all PER traps, enter:
DISPLAY SLIP,PER