The following is an overview of the procedures required to complete
the ACS routine testing phase. Apply this process to each new data
subtype until all data has been migrated. For the specific procedure,
see
Testing procedures.
- After a sample of the data sets that are to be tested has been
chosen (or created), a base line test set is generated, to represent
the ACS routines before they are changed.
- After the base line test set has been created, the ACS routines
are changed (but not activated) to manage the data type. The same
set of test cases is then run through ACS testing, generating a new
ACS listing.
- A comparison test is run against the base line test set, and the
new listing and exceptions are reported in a comparison report. If
the change to the ACS routines was made correctly, the exceptions
reported should contain only the new test cases.
- If no errors occur after converting the data to SMS management,
the test cases are updated to reflect the expected results for future
regression testing.
- The current configuration is saved and the new configuration is
activated. After the activation, conversion of data to SMS management
can proceed.