Under the following environmental
conditions, SMS might
not separate two data sets that are
specified
for required or preferred separation:
- Allocation is not SMS-managed.
- Allocation is performed
on a system in the SMS complex that runs
a prior version of SMS that does not support data set separation.
- During switching or activation of an SMS configuration, the data
set separation profile cannot be accessed or fails validation.
- A
service that is allocating a temporary data set name does not
provide the real data set name to SMS.
- Two data sets that
are specified to be separated are allocated
at the same time by two different tasks or two different systems.
For performance reasons, SMS does not serialize data set allocations.
- A volume is varied online during allocation.
- An IODF change
occurs during allocation.
- A data set name that is not listed
in the data set separation
profile is specified during DFSMShsm recover.
- A data set separation
profile might have been modified after the
configuration was activated. This can result in differences between
the data set separation profile data set and the active copy of the
data set separation profile.
- SMS does not perform data set
separation during RENAME.
- SMS does not perform data set separation
during DFSMShsm migration
to level 1 or level 2 storage.
- SMS does perform data
set separation during
DFSMShsm recall.
- SMS does not perform data set separation
during full volume image
copy.
SMS might not issue the corresponding warning
message IGD17372I
in those cases where allocation was successful and data set separation
was not honored.