Use the MVS LIBRARY DISPCL command to display the media type of
scratch volumes that you want loaded into the cartridge loader of
a library-resident tape drive. The syntax of the LIBRARY DISPCL command
follows:
>>-+-LIBRARY-+--+-DISPCL-+--,device_number---------------------><
'-LI------' '-DC-----'
- DISPCL | DC
- Specifies a request to display the media type of scratch volumes
you want loaded into the cartridge loader for a library-resident tape
drive.
- device_number
- Specifies the MVS device number of a library-resident tape drive.
Note: The display output for the DISPCL command is the same
as the output for the DISPDRV command for a single drive. See
Displaying tape drive status for an example.