To enter an unlabeled optical disk into a 3995 optical library:
CBR2550I Optical disk entry into library library-name scheduled.
_______________________________________________________
CBR3381I Volume mounted on drive on drive-name contains an unrecognized format.
_______________________________________________________
CBR4438D Volume in drive-name has unrecognized media format.
Reply ‘F’ to format or ‘C’ to cancel.
This message is unique to a 3995 library. It is issued when a volume has been entered that is either unlabeled or of a format not known to the library. A reply of ‘F’ causes the volume to be formatted and any data existing on the volume is destroyed. Replying ‘C’ at this point causes the formatting processing to stop, leaving only the one side of the optical cartridge formatted.
_______________________________________________________
CBR4412D Enter VOLSER for volume on drive drive-name in library library-name.
_______________________________________________________
CBR4424D VOLSER for unlabeled volume in drive drive-name is volser. Reply ‘U’
to use this volser, or ‘R’ to retry.
_______________________________________________________
CBR4439D Enter VOLSER for opposite side of volume volser in drive drive-name.
_______________________________________________________
CBR4424D VOLSER for unlabeled volume in drive drive-name is volser. Reply ‘U’
to use this volser, or ‘R’ to retry.
_______________________________________________________
CBR4406D Enter owner information for volume volser on drive drive-name.
_______________________________________________________
CBR4432D Enter storage-group-name for volumes volser1 and volser2, or reply ‘U’
to assign to scratch.
_______________________________________________________
CBR4401I Volume volser2 mounted on drive drive-name.
_______________________________________________________
CBR2100I Volumes volser1 and volser2 entered into library: library-name.
_______________________________________________________
The two volumes on the optical disk are added to a storage group or are assigned to scratch status and are available for use. In the message text, volser1 and volser2 are replaced by the volume serial numbers you entered for the optical volumes.
For further information about commands from the 3995 dynamic console, see the 3995 Operator Guide for C-Series Models.