The OAM display volume command shows information about tape and
optical volumes associated with object support.
The following command
syntax displays volume status:
>>-+-DISPLAY-+--SMS,-+-VOLUME-+-(volser)-+----------------+----><
'-D-------' '-VOL----' '-,L=-+-a------+-'
+-name---+
'-name-a-'
- DISPLAY
- Specifies the OAM display command.
- VOLUME,volser
- Displays the status of the requested tape or optical volume. There
is no option to display all volumes known to the system; however,
you can use ISMF to display the optical and tape volume lists.
- L={a | name | name-a}
- Specifies the location where the results of the inquiry are to
be displayed, where name is the console
name, and a is the display area on the console
screen.
To display optical or object tape volume status, enter the following
command:
DISPLAY SMS,VOLUME(volser)
This
results in F OAM,D,VOL,volser command being issued.
Specifying volser displays the status
of the requested optical volume and its opposite-side volume.