You can use a SETOAM statement to direct all objects for an Object
or Object Backup storage group to a specific tape type by specifying
the TAPEUNITNAME(device-type) parameter that
is associated with the storage group.
The following are examples of directing objects to specific tape
device types using the TAPEUNITNAME parameter of the SETOAM statement:
- If 3490 is the TAPEUNITNAME parameter, then objects written to
the subject Object or Object Backup storage group would all have this
unit name recorded in the tape volume table. Objects written to the
Object or Object Backup storage group would all be written to 3490
devices.
- If the TAPEUNITNAME(3490) is changed to a new device type, such
as TAPEUNITNAME(3590), OAM continues to write to the available usable
tape volumes that are associated with the Object or Object Backup
storage group using 3490 devices until an MVS scratch allocation is
required. When an MVS scratch tape is required to handle an out-of-space
condition for the Object or Object Backup storage group, that scratch
tape is written on a device that is specified by the SETOAM TAPEUNITNAME
statement for that group, which is 3590 in this example.
OAM continues
to read the objects that were previously written on 3490 devices for
the Object or Object Backup storage group so long as there is a 3490
device available for allocation at the time the read is requested.
Note: If a tape volume that was previously written on a 3490 device
is entered into an ATLDS or MTL, that tape volume continues to be
used as long as the ATLDS or MTL to which it was entered contains
a compatible device.
See Using dynamic allocation for tape drives for information concerning compatible
devices not being available to handle requests.