Dynamically enabling use of a new coprocessor or accelerator
to a partition requires that:- At least one usage domain index be defined to the logical partition.
- The usage domain list is a subset of the control domain list.
- The cryptographic coprocessor number or numbers be defined in
the partition Candidate list.
The same usage domain index may be defined more than once across
multiple logical partitions. However, the cryptographic coprocessor
number coupled with the usage domain index specified must be unique
across all active logical partitions.
The same cryptographic coprocessor number and usage domain index
combination may be defined for more than one logical partition. In
such a configuration, only one of the logical partitions can be active
at any time. This may be used, for example, to define a configuration
for backup situations.
Table 1 illustrates a simplified
configuration map.
Each row identifies a logical partition and each column a cryptographic
coprocessor, installed or in plan. Each cell, indicates the Usage
Domain Index number or numbers planned to be assigned to the partition
in its image profile (it is recommended to work from a spreadsheet).
There is a potential conflict when, for a given row, different cells
contain more than once the same domain number.
Table 1. Planning LPARs domain
and cryptographic coprocessor. Planning LPARs domain and
cryptographic coprocessorcoprocessor ID |
AP0 |
AP1 |
AP2 |
AP3 |
AP4 |
AP5 |
AP6 |
... |
LPAR lp0 |
0 |
0 |
|
|
|
0 |
0 |
|
LPAR lp1 |
|
|
0 |
0 |
0 |
|
|
|
LPAR lp2 |
0 |
0 |
0 |
0 |
0 |
|
|
|
LPAR lp4 |
4
14
|
4
14
|
4
14
|
4
14
|
4
14
|
4
14
|
4
14
|
|
LPAR lp5 |
|
|
|
1 |
1 |
1 |
1 |
|
.../... |
|
|
|
|
|
|
|
|
Within a row, the domain index number or numbers specified are
identical because the domain index applies to all cryptographic coprocessors
selected in the partition Candidate list. In the example:
- Logical partitions lp0 and lp1 use domain 0 but are assigned different
cryptographic coprocessors. The combination domain number and cryptographic
coprocessor number is unique across partitions. Both partitions lp0
and lp1 can both be active at the same time.
- Logical partition lp4 uses domain 4 and 14. Since no other partition
uses the same domain numbers, there is no conflict.
- Logical partition lp5 uses domain 1 and no other partition uses
the same domain number. Again, there is no conflict.
- Logical partitions lp2 use domain 0, on the set of cryptographic
coprocessors already used by lp0 and lp1. Partition lp2 cannot be
active concurrently with lp0 or lp1. However, this may be a valid
configuration to cover for backup situations.