S550-0435-04
OFFSETYB
OFFSETYB
Specifies the offset in
the y direction of the logical page origin from the media origin for
the back side of each sheet. If OFFSETYB is not specified, the value
specified in the form definition is used.
You can specify the OFFSETYB parameter in an OUTPUT statement,
as follows:
-
OFFSETYB=nnnn[.mmm]unit
- The values are:
- nnnn
- Specifies the one- to four-digit number that indicates the offset
for the back side of each sheet.
- mmm
- Specifies the one- to three-digit decimal number that indicates
the offset for the back side of each sheet.
- unit
- Specifies one of these measurement units:
- IN
- Inches
- CM
- Centimeters
- MM
- Millimeters
- PELS
- Picture elements (1/240 inch)
- POINTS
- Points (1/72 inch)
Note:
If you specify the unit as PELS or POINTS, you
must specify the value as a whole number with no decimal point.
|