IEF115I

Explanation
The allocation request failed because the request
required more tape devices than contained in any eligible system-managed
tape library. Message IEF114I, which displays the eligible device
pools, might accompany this message.
If a dynamic ACTIVATE was
done while the job was in allocation, any new devices or device pools
added by the new configuration are not available to the job, because
jobs in the recovery allocation are still locked onto the Eligible
Device Table (EDT) for the previous configuration. The new configuration
does not become available until the job ends, or is cancelled, then
is submitted again.
In the message text: jobname
The name of the job.
procstep
The name of the step in the cataloged procedure.
stepname
The name of the job step.
ddname
The name of the DD statement.
+ xxx
The relative position of a data set within a concatenation of
data sets, including all data sets implicitly concatenated (through
GDG ALL or OPTCD=B requests). See z/OS MVS JCL User's Guide for
more information on GDG ALL or OPTCD=B requests when used within a
set of concatenated data sets. The first data set of a concatenation
would be +000, but the value +000 is never shown.
ddd
The number of tape devices required.

System action
The system fails the allocation request.

System programmer response
Ensure that sufficient tape device
pools are defined to this system. Then, resubmit the request. If the
failure occurred while the job was in recovery allocation, and a dynamic
ACTIVATE was done at the same time, resubmit the job when the activate
completes.

Programmer response
Reduce the number of tape devices required
by this DD statement and then resubmit the job. If this is not possible,
notify the system programmer.

Source
Allocation

Module
IEFAB424

Routing code
11

Descriptor code
6