Explanation
The system cannot process a CONTROL command as
entered. Supply more information or correct the command.
In
the message text:
- cm
- The command verb.
- text
- One of the following lines:
- SPECIFY DISPLAY ID
- A CONTROL C,D command was entered without an ID parameter.
- SPECIFY L OPERAND
- A CONTROL command for an out-of-line display, such as a frame
or erase command, was issued without the routing location parameter,
L=cca, and more than one display exists on the screen.
- SPECIFY MESSAGE ID
- A CONTROL C,A or CONTROL C,E or CONTROL C,CE or CONTROL C,I command
was entered without an ID parameter.
- DUPLICATE OPERAND
- A keyword was specified more than once on a CONTROL V command.
- COMMAND ISSUED IS command
- command is the text of the command that was
originally entered.
System action
The system rejects the command.
Operator response
If
cm is the following,
do the following:
- CONTROL C,D
- To cancel a display with this command, specify the ID of the display
to be ended: CONTROL C,D,ID. The ID is at the extreme right side of
the control line of the display.
- CONTROL command for an out-of-line display, such as a FRAME or
ERASE command
- The display area ID of must be specified in an L parameter.
- CONTROL command with additional parameters or data
- Specify the additional parameters or data.
- CONTROL V with duplicate keywords
- Respecify the command without duplicate keywords.
Source
Module
IEE2003D, IEE7703D, IEE7803D, IEE8103D
Routing code
Descriptor code