Explanation
A SLIP SET command was specified without an END
parameter. Message IEE725I, which lists the SLIP parameters, preceded
this message. Reply to this message to do one of the following:
- Add new SLIP parameters
- Change existing SLIP parameters
- Accept the parameters already specified
- Cancel the SLIP command
In the message text:
- ‘END’
- A SLIP command, other than SLIP MOD or SLIP DEL, was entered.
System action
The system waits for the operator to reply.
Operator response
Do one of the following:
- Reply REPLY id,prm,prm,...,[END]
to add parameters or to change the parameters indicated in message
IEE725I.
To complete the SLIP SET command, specify END as the last
parameter. If END is not specified, the system will issue message
IEE725I again to display the updated list of parameters.
The
reply can add or change any parameter in any order, except the following
positional parameters. These parameters must be added immediately
after the SET parameter:
New parameters replace original parameters in their entirety.
If
an incomplete SLIP parameter was specified (for example, if the closing
parenthesis was omitted on the last parameter), continue the parameter
and complete it in the beginning of the reply.
- Reply REPLY id,CANCEL to cancel the original SLIP command.
- Reply REPLY id,END to accept the parameters in message IEE725I.
id is the identifier preceding the
message number.
Source
Module
Routing code
Descriptor code