Explanation
While processing a command, the system detected
that a function is not supported.
In the message text:
- func
- The function, which is one of the following:
- LOG
- The system log and OPERLOG are inactive.
- WRITELOG
- The system log is not active because a WRITELOG CLOSE command
had been entered or the system log task ended abnormally.
- DDR SYSRES
- Dynamic device reconfiguration (DDR), or the SYSRES option of
DDR, is not supported. The system cannot complete the SWAP request
entered by the operator.
- NET
- Virtual telecommunications access method (VTAM®)
is not active.
func may also be a command dependent
upon a selectable unit. If it is such a command, the selectable unit
supporting the command has not been installed on the system.
System action
The system rejects the command.
Operator response
Depending on the message text, do the following:
- LOG
- If the system log, OPERLOG, or both should be maintained, contact
the system programmer.
- WRITELOG
- If the system log should be maintained, contact the system programmer.
- DDR SYSRES
- No response.
- NET
- Do not enter VARY, DISPLAY or HALT NET commands until VTAM is
active.
- Command dependent upon a selectable unit
- Do not use the command until the selectable unit has been installed
on the system.
Source
Module
IEE1403D, IEE1603D, IEE3203D, IEE3503D, IEE5703D
Routing code
Descriptor code