Explanation
A FORCE command requested that a job be removed
from the system. The system issues this message for one of these reasons:
- The job can be canceled. Use the CANCEL command.
- The job or procedure cannot be canceled. Use the FORCE nnn,ARM
command.
In the message text:
- jobname
- One of the following:
- The name of the job removed in response to the command.
- The job name of a task created by the START or MOUNT command (includes
the identifier, if it was specified on the START or MOUNT command
that created the task).
- The name of an advanced program-to-program communications (APPC)
transaction program (TP).
- STARTING, if initiation of a started job, task, or ATX
is complete.
- CANCELABLE - ISSUE CANCEL BEFORE FORCE
- The job can be canceled.
- NON-CANCELABLE - ISSUE FORCE ARM
- The job or procedure cannot be canceled.
System action
The system rejects the command.
Operator response
Reply according to the message text by entering
a CANCEL or FORCE ARM command for the job.
If the system does
not end the job after a reasonable time, enter the CANCEL or FORCE
ARM command again; multiple CANCEL or FORCE ARM commands may be required
to remove the job.
If the job is not removed, enter the FORCE
command without the ARM parameter.
Source
Module
Routing code
Descriptor code