Explanation
An active SLIP trap requests an action of WAIT.
The conditions specified on the SLIP command have been met. The system
enters a wait state, as requested.
PSAWTCOD in the prefixed
storage area (PSA) points to a 28-byte field:
01ccccxxrrrrrrrrppppppppssssssssllllllllzzzzzzzzgggggggg
Recovery termination manager 1 (RTM1) functional recovery
routine (FRR)type of entry.
2ccccxxrrrrrrrrppppppppwwwwwwwwllllllllzzzzzzzzgggggggg
RTM2 ESTAE type of entry (RTM2WA).
03ccccxxrrrrrrrrppppppppaaaaaaaallllllllzzzzzzzzgggggggg
Address space ending type of entry.
04ccccxxrrrrrrrrppppppppiiiiiiiillllllllzzzzzzzzgggggggg
Program event recording (PER) interrupt type of entry.
The
variable information in the field is as follows:
- cccc
- A pointer to the logical CPU id of the processor where the event
was detected.
- xx
- Irrelevant information.
- rrrrrrrr
- A pointer to the general registers.
- pppppppp
- A pointer to the program status word (PSW).
- ssssssss
- A pointer to the system diagnostic work area (SDWA).
- llllllll
- A pointer to control registers 3 and 4.
- zzzzzzzz
- A pointer to the access registers.
- wwwwwwww
- A pointer to the RTM2 work entry.
- aaaaaaaa
- A pointer to the address space control block (ASCB).
- iiiiiiii
- A pointer to the PER interrupt code.
- gggggggg
- A pointer to the high 32 bits of the 64-bit GPRs, or 0 if not
available.
System action
The system issues message IEA992I before the system
enters the restartable, disabled wait state.
Operator response
Follow the directions of the system programmer
for the SLIP trap. Then restart the system by invoking the restart
function.
Source
Recovery termination manager (RTM)