008

Explanation
The error occurred during processing of a SYNAD
routine.  The routine was given control following processing of a
BSAM CHECK macro instruction.
The SYNAD routine returned control
to the control program for the CHECK macro instruction.

System programmer response
  If the error recurs and the program
is not in error, look at the messages in the job log for more information.
Search problem reporting data bases for a fix for the problem. If
no fix exists, contact the IBM® Support
Center. Provide the JCL and the program listing for the job.

Programmer response
Correct the SYNAD routine so that the control
program save area is not destroyed. Then run the job step again.

Source
DFSMSdfp