Job Control Statements

Table 1 shows the job control statements for IEHMOVE.

Table 1. IEHMOVE job control statements
Statement	Use
JOB	Starts the job.
EXEC	Specifies the program name (PGM=IEHMOVE) or, if the job control statements reside in a procedure library, the procedure name. This statement can also include optional parameter information.
SYSPRINT DD	Defines a sequential data set for messages. The data set can be written onto a system output device, a magnetic tape volume, or a direct access volume.
SYSUT1 DD	Defines a volume on which three work data sets required by IEHMOVE are allocated.
anyname DD	Defines a permanently mounted or mountable DASD volume. At least one permanently mounted volume must be identified.
tape DD	Defines a mountable tape device.
SYSIN DD	Defines the control data set. The data set, which contains utility control statements, usually follows the job control statements in the input stream; however, it can be defined either as a sequential data set or as a member of a procedure library.

Since SYSUT2 and SYSUT3 are reserved for IEHMOVE, it is not recommended to use them in an IEHMOVE job step.