0 (0) |
0 (0) |
The operation was successful. |
8 (8) |
4 (4) |
An invalid dsname_length was specified.
Correct the dsname_length argument and retry
the request. |
8 (8) |
8 (8) |
An invalid dsname of blanks was specified.
Correct the dsname argument and retry the
request. |
8 (8) |
20 (14) |
IGWARLS is only supported for VSAM data sets. The name specified
was not the name of the base cluster. Specify the name of the base
cluster in the dsname argument and retry the request. |
8 (8) |
32 (20) |
The data set specified in dsname is
not an SMS managed data set. Correct the dsname argument
and retry the request. |
8 (8) |
40 (28) |
For IGWARLS, the logstreamid_length specified was invalid (<=0)
or was not large enough to return the requested logstreamid. Correct
the logstreamid_length argument and retry
the request. |
12 (C) |
8 (8) |
There is insufficient virtual storage to process the request.
Retry the request. If the condition persists, contact IBM® for programming assistance. |
12 (C) |
12 (C) |
The data set specified in dsname could
not be found. Verify that the data set exists and has been correctly
specified in dsname. |
12 (C) |
14 (E) |
The data set specified in dsname was
found in the catalog but its attributes were not available. Verify
that the data set has been correctly specified in dsname. |
12 (C) |
16 (10) |
Cannot access the data set that is specified in dsname.
The data set has been HSM migrated. HRECALL the data set and retry
the request. |
16 (10) |
4 (4) |
An error occurred on a call to catalog management. The catalog
return code is in the first element of prob_det and
the catalog reason code is in the second element of prob_det.
See message IDC3009I for an explanation of the catalog return code
and reason code. A catalog management return code of 8 indicates that
the specified data set was not found. If you get this return code,
correct dsname and retry the request. |
20 (14) |
4 (4) |
A system error occurred during IGWARLS processing. The elements
of prob_det contain additional diagnostic
data. Contact IBM for programming
assistance and provide them with the IGWARLS return_code,
reason_code, and prob_det values. |
36 (24) |
4 (4) |
Linkage cannot be established to the IGWRLS service module,
IGWAMCS4. Either the wrong level of the operating system is being
used, or the callable system service library, SYS1.CSSLIB, is missing
the required services. Contact your installation system programmer
for assistance. |