EZD1288I

Explanation
The initialization of the AT-TLS GROUP group_name did
not complete successfully because of the reason specified.
In
the message text:Tcpname
The name of the TCPIP stack
group_name
The name of the AT-TLS group specified on a TTLSGroupAction statement
reason
Additional information about why the initialization of the group
failed. reason is one of the following:ICSF
UNAVAILABLE FOR FIPS140 MODE GROUP – ICSF was not active when tcpname initialized
the AT-TLS group group_name, which is configured
with FIPS140 On. ICSF is required for FIPS140 support.

System action
 TCPIP continues. The AT-TLS group group_name is
marked as failed. Any connections attempting to use that group  will
be reset. AT-TLS sets a return code of 5018 for those connections.

Operator response
 Contact the system programmer.

System programmer response
Use the reason to
resolve the initialization failure.
For reason ICSF
UNAVAILABLE FOR FIPS140 MODE GROUP:
If the AT-TLS group needs to be FIPS140 enabled, start ICSF before
installing the AT-TLS policy. To attempt starting the AT-TLS group
again after ICSF is active, refresh the AT-TLS policy as described
in Action refresh in z/OS Communications Server: IP Configuration
Guide.
 If the AT-TLS group does not need to be FIPS140 enabled, specify
FIPS140 Off on the TTLSGroupAction statement. Refresh the AT-TLS policy
as described in Action refresh in z/OS Communications Server: IP Configuration
Guide.

User response
None.

Problem determination
See the system programmer response.

Source
z/OS® Communications
Server TCP/IP

Module
 EZBTLMST

Routing code
2, 8

Descriptor code
12

Automation
This message goes to the console. Automation can
notify the system programmer.

Example
  EZD1288I TCPCS AT-TLS GROUP grp_act1 INITIALIZATION FAILED - ICSF UNAVAILABLE FOR FIPS140 MODE GROUP