EZD1172E

Explanation
 Sysplex problem detection determined that there
are no routes available to  any partners. 
 tcpstackname is
the name of the TCP/IP stack. 
 timevalue is
the number of seconds that connectivity was not available.

System action
 TCP/IP continues.   If the GLOBALCONFIG  SYSPLEXMONITOR  RECOVERY option is active
and this stack is not the only member of its TCP/IP sysplex  group,
the following RECOVERY actions will occur:  This stack will leave the TCP/IP sysplex group.  
This stack will no longer participate in sysplex distribution
(as a distributor or target) or act as an owner or a backup for DVIPAs.
 All DVIPAs defined on this stack will be deactivated; however, the
DVIPA definitions will be saved.   
If the problem is corrected, this operator message will be deleted;
if the GLOBALCONFIG SYSPLEXMONITOR AUTOREJOIN option is active, the
stack will process the DVIPA definitions and rejoin the TCP/IP sysplex
group.

If the GLOBALCONFIG  SYSPLEXMONITOR  NORECOVERY option is active,
no action  will be taken.  If the problem is corrected, this operator
message will be deleted.

 See the information about sysplex
problem detection and recovery in z/OS Communications Server: IP Configuration
Guide for more information.
 See the information
about the GLOBALCONFIG statement in z/OS Communications Server: IP Configuration
Reference for the definition of the SYSPLEXMONITOR
parameters.

Operator response
 Contact the system programmer.

System programmer response
 Issue Netstat ROUTe/-r to determine
which interfaces are used by the VIPAROUTE statements. Issue the Netstat
DEvlinks/-d command to show which interfaces are active;  check the
system log for  any messages related to the status of interfaces.
 If  you cannot  determine why the routes were lost, see the information
about diagnosing OMPROUTE  problems in z/OS Communications Server: IP Diagnosis Guide for additional  information. 
 If this
problem can be corrected, this operator message will be deleted.
 If
RECOVERY and NOAUTOREJOIN are active, then issue the VARY TCPIP,,SYSPLEX,JOINGROUP
command to cause the DVIPA definitions to be processed, and the stack
to rejoin the TCP/IP sysplex group.
 If RECOVERY and AUTOREJOIN
are active, no futher actions are needed. The stack will process the
DVIPA definitions and rejoin the TCP/IP sysplex group.
 If NORECOVERY
is active, no further actions are needed. 
 After connectivity
is reestablished, if RECOVERY is active,  wait until message EZD1172E
is issued  when the  process of leaving the  sysplex group completes
successfully.   Then issue the  VARY  TCPIP,, SYSPLEX,JOINGROUP  command
to cause the stack to rejoin the  sysplex group.  If NORECOVERY is
active, no further actions are needed.

Module
 EZBXFPDM

Procedure name
  EZBXFPDM