LINK return codes

00

LINK processing completed successfully.

04

LINK processing completed with possible errors:

The linkage editor returned an acceptable, but nonzero, return code.
A designated load module was not in its SYSLIB.
A distribution zone copy of a module was used, but it was at a different service level from the target zone copy.

08

The linkage editor returned a return code greater than the threshold return code.

12

LINK processing stopped. These are some possible errors:

The LINK command contained a syntax error.
A previous command issued an unacceptable return code.
A target library ran out of space (X37 ABEND).
A DD statement required by SMP/E was missing.
A CSI was not available.
A required module could not be found or was not installed.
A required load module did not exist (no LMOD entry).
A required load module was a copied load module.
A designated load module already contained a designated module by the same name from another zone.
None of the load modules specified on the INTOLMOD operand are installed in a system library.

16

A severe error caused SMP/E processing to stop.