SMP/E for z/OS Messages, Codes, and Diagnosis
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


RESTORE error recovery

SMP/E for z/OS Messages, Codes, and Diagnosis
GA32-0883-01

After the RESTORE command completes, examine SMPOUT and SYSPRINT output to determine the relative success of the command. Check any reports that were produced.

For any partially restored SYSMODs, SMP/E sets the RESTORE and ERROR status indicators in the affected target zone SYSMOD entries.

You should rerun RESTORE for a SYSMOD that failed during previous RESTORE processing. The following processing takes place when you rerun RESTORE:
  • All linkage editor processing is repeated.
  • All IEBCOPY processing is repeated.
  • All assemblies are repeated.
  • All IEBUPDTE processing is repeated.

If any library runs out of space during RESTORE processing, see Diagnosing SMP/E problems and SMP/E for z/OS Commands for information on how to handle the problem. Then rerun RESTORE.

Parent topic: RESTORE return codes

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014