GENERATE return codes

00

GENERATE processing completed successfully.

04

GENERATE processing completed, but there are potential errors in the generated jobs. Refer to the messages for more information about these errors.

08

GENERATE processing completed, but SMP/E found potential errors when it analyzed entries in the target zone. These errors may cause problems when you run the generated jobs. Review each message for more information about the errors and follow the directions in the “Programmer Response” topic of each message. These are some possible errors:

SMP/E did not find the JOBCARD member in the specified data set.
SMP/E did not find an ASSEM or SRC entry in the target zone.
SMP/E could not assemble the identified module.
The element entry is missing a subentry (FMID or DISTLIB).
The LMOD entry had no MOD entries to show that the module was a part of that load module.
The DDDEF entry defining the target library for a hierarchical file system element did not contain a PATH subentry.

12

GENERATE processing stopped. One possibility is that an operand was missing from the command.

16

An I/O error caused SMP/E processing to stop.