SMP/E for z/OS Messages, Codes, and Diagnosis
Previous topic | Next topic | Contents | Contact z/OS | Library | PDF


GIM25101S

SMP/E for z/OS Messages, Codes, and Diagnosis
GA32-0883-01

GIM25101S
WHEN THE operand OPERAND IS SPECIFIED, THE command COMMAND MUST SPECIFY AT LEAST ONE zonetype ZONE.

Explanation

operand
operand
command
SMP/E command (RECEIVE, REJECT or REPORT)
zonetype
TARGET or DLIB

For the RECEIVE command, the FORTGTZONES operand was specified, but did not specify a target zone or a ZONESET that contains target zones.

For the REJECT command, one of the following occurred:
  • The command specified the PURGE operand, but did not specify a DLIB zone or a ZONESET that contains DLIB zones.
  • The command specified the TARGETZONE operand, but did not specify a target zone or a ZONESET that contains target zones.
For the REPORT command, one of the following occurred:
  • The command specified the DLIBZONE operand, but the specified ZONESET or zones specified on the ZONES operand contain only target zones.
  • The command specified the TARGETZONE operand, but the specified ZONESET or zones specified on the ZONES operand contain only DLIB zones.

System action

Command processing stops.

Programmer response

Specify the required type of zone for the indicated operand. Then rerun the job.

Parent topic: Diagnostic messages

Go to the previous page Go to the next page

Notices | Terms of use | Support | Contact z/OS | zFavorites



Copyright IBM Corporation 1990, 2014