Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
The SPLIT command z/OS ISPF User's Guide Vol I SC19-3627-00 |
|
You enter split-screen mode by using the SPLIT command. You also use this command to reposition the horizontal line that separates the two logical screens on a 3270 display. On a 3270 display the location of the cursor identifies the active logical screen. On a 3270 display, the horizontal divider line that separates the logical screens is not considered part of either logical screen. If the cursor is placed on this horizontal divider line and a function key is pressed, the result is the same as if the ENTER key was pressed and the cursor is positioned on the active logical screen's command line. Because ISPF runs in both host and GUI modes, the SPLIT command behaves differently in each.
End split-screen mode by ending the application on all but one logical screen. The remaining logical screen is then expanded to the full size of the display screen. |
Copyright IBM Corporation 1990, 2014
|