Previous topic |
Next topic |
Contents |
Contact z/OS |
Library |
PDF
Deciding whether to dynamically enable z/OS Planning for Installation GA32-0890-02 |
|
By describing the situations that require dynamic enablement, this section helps you decide whether you need to dynamically enable. A priced feature was not in your original order for a specific
processor (as identified by a specific processor serial number) but
you now want to use it on that processor. If this is the case,
then follow the steps starting with Dynamic enablement Step 1: Notify IBM.
The priced features are:
You are licensed for a product that is also a nonexclusive priced feature and the license is on a processor other than the one to which your z/OS® order applies. To allow your installation flexibility as you migrate to z/OS, you can run the separate product versions of the z/OS nonexclusive priced features (or, in one case, a component of a nonexclusive priced feature). Running the separate product version of such a z/OS feature means you do not have to order and install the z/OS feature. The products that are also z/OS nonexclusive
priced features are:
If your order included separate product versions of these features, the separate versions are enabled in the IBM-supplied IFAPRD00 member. If you are licensed for such products on a processor other than the one to which your z/OS order applies, you must specifically enable them because the IBM-supplied IFAPRD00 does not. Follow the steps starting with Dynamic enablement Step 1: Notify IBM. You are licensed for DCF on a processor other than the one to
which your z/OS order applies,
or not licensed at all. The product DCF (5748-XX9) can be dynamically
enabled. To use DCF, you must do one of the following:
You are licensed for the alternate base but now want to use the standard base. IP Services, the component of element Communications Server that supports TCP/IP networking, supports dynamic enablement because of the z/OS alternate base configuration. (Refer to Alternate base.) IP Services is shipped enabled if you order the standard z/OS base but disabled if you order the alternate base. Thus, if you are licensed for the alternate base but now want to be licensed to use the standard base, you must enable IP Services (using the name TCP/IP). Follow the steps starting with Dynamic enablement Step 1: Notify IBM. |
Copyright IBM Corporation 1990, 2014
|