On the IPL Attribute List, view or
modify the attribute values for IPLADDR and IPLPARM.
Use F20=Right
to move the screen to the right to view the IPL attributes used for
the last IPL.
The IPL ADDR column
shows the LOAD address used for next IPL.
The Next IPLPARM column shows the LOAD parameter
used for z/OS and is a concatenation of the following attributes:
IODF Device, LOADxx Suffix, Prompt/Message Option, and Nucleus Suffix.
An additional column shows unformatted IPL parameters. You can use
these unformatted values to specify non z/OS IPL parameters, for
example, for z/VM or Linux on System z for the next IPL. This unformatted
string can be up to eight characters long. HCD does not perform any
semantic checks of these values, as the content depends on the operating
system for which they are used.
When providing input
to the unformatted IPL parameters, you must specify the value at the
correct position in the string. For non-specified leading or intermediate
characters, use a period (.) instead of a blank, since blanks are
removed by ISPF.
You cannot type values into both
the left four columns and the right Unformatted column
of Next IPLPARM. If you provide values
into the Unformatted column, they are
transferred into the left four columns.
The IPL ADDR and/or the Next
IPLPARM values for the next IPL are taken, when 'Use dynamically
changed IPL address' and/or 'Use dynamically changed IPL parameter'
are selected on a LOAD profile that is used to initiate an IPL, or
to activate an operating system. This enables you to change the values
of IPLADDR and IPLPARM without updating the profile.