Use this command to change the message propagation option status.

>>-prefix--+-MODIFY-+--,LOG,MSGPROP=(YES|NO)-------------------><
           '-F------'                          

prefix

is the prefix that is appropriate for your console or terminal. Do not use a prefix when submitting commands in a batch job.

LOG

specifies the BDT system log.

YES

specifies message propagation is to be enabled. This option will allow the BDT system to route messages that come from another BDT system to the nodes in routing table.

NO

specifies message propagation is to be disabled. This option will prevent messages coming from another BDT system from being routed to the BDT nodes in the routing table. This does not affect the routing of messages that do not come from another BDT system as the output device for the system log.

If you specify MSGPROP=YES, you may expose your BDT system to a possible message loop if any of the BDT nodes route messages to a node that has already routed the message.