Registering clients
Register a client to ensure that the client can connect to the server, and the server can protect client data.
Before you begin
Restriction: For some types of clients, the
client node name and the administrative user ID must match. You cannot authenticate those clients by
using the Lightweight Directory Access Protocol authentication method that was introduced in V7.1.7.
For details about this authentication method, sometimes referred to as integrated mode, see Authenticating users by using an Active Directory database.
Procedure
To register a client, complete one of the following actions.
- If the client requires an administrative user ID, register the client by
using the REGISTER NODE command and specify the USERID
parameter:
where node_name specifies the node name and password specifies the node password. For details, see Register a node.register node node_name password userid=node_name
- If the client does not require an administrative user ID, register the client by using the
Operations Center Add Client wizard. Complete the following steps:
- On the Operations Center menu bar, click Clients.
- In the Clients table, click +Client.
- Complete the steps in the Add Client wizard:
- Specify that redundant data can be eliminated on both the client and server. In the Client-side data deduplication area, select the Enable check box.
- In the Configuration window, copy the
TCPSERVERADDRESS, TCPPORT, NODENAME,
and DEDUPLICATION option values.Tip: Record the option values and keep them in a safe place. After you complete the client registration and install the software on the client node, use the values to configure the client.
- Follow the instructions in the wizard to specify the policy domain, schedule, and option set.
- Set how risks are displayed for the client by specifying the at-risk setting.
- Click Add Client.