Modifying running stubs
If you are using IBM® Rational® Integration Tester to
run a stub, you can modify the stub while it is running.
About this task
Note: If you are using Rational Integration Tester 8.0.1
(or later), clicking default case console output or failed validation
console output on the Test Lab perspective’s Console window
opens the Message Differences window, which enables you to debug the
stub. (For information about debugging a stub, refer to Debugging
Message-Based Stubs. For general information about the Message Differences
window, refer to Rational Integration Tester reference.)
To modify a running stub:
Procedure
- In Rational Integration Tester’s Test Factory perspective, double-click the stub to open it in the Stub Editor.
- Use the Stub Editor to make and save any required changes to the stub. (For information about using the Stub Editor, refer to Modifying message-based stubs.)
- Open the Test Lab perspective.
Results
The Task Monitor window shows that the modified stub was stopped and restarted by Rational Integration Tester.