Using the Workload Activity Reports, you can observe the
measurements in the service and reporting classes.
About this task
The following RMF1 job reads the data from RMF data
buffers.
Procedure
- Run the RMF Monitor 1 post processor as a
batch job which can read the RMF data buffers from memory and
produce a report.
The sample job that follows will
run the RMF Monitor 1 post processor (You will need to
change the time and date parameters.)
//RMF1JOB JOB 1,CLASS=A
//RMFPP EXEC PGM=ERBRMFPP,REGION=0M
//MFPINPUT DD DISP=SHR,DSN=SYS1MANE
//MFPMSGDS DD SYSOUT=*
//SYSIN DD *
SYSOUT(O)
NOSUMMARY
SYSRPTS(WLMGL(SCPER(WSHIGH,WSMED,WSLOW,SYSSTC,OPS_DEF)))
DATE(04172003,04172003) /* <== SET TO MEAS. DATE MMDDYYYY */
RTOD(1430,1500) /* <== SET TO MEAS. TIME OF DAY HHMM*/
DINTV(0002)
/*
//
This will take the raw SMF data, in this case the
MANE data, and produce the workload activity report as an H output
class in SDSF.
- Using the Workload Activity Reports, observe the measurements
in the service and reporting classes. After your measurement run is
over, you should reset the SMF parameters to their standard settings
with the SET SMF=xx command.