Restoring the Virtual I/O Server from tape
You can restore the Virtual I/O Server base code, applied fix packs, custom device drivers to support disk subsystems, and some user-defined metadata from tape.
About this task
To restore the Virtual I/O Server from tape, follow these steps:
Procedure
- Specify the Virtual I/O Server logical partition to boot from the tape by using the bootlist command. Alternatively, you can alter the bootlist in the System Management Services (SMS).
- Insert the tape into the tape drive.
- From the SMS menu, select to install from the tape drive.
- Follow the installation steps according to the system prompts.
- If you restored the Virtual I/O Server to a different
system from which it was backed up, then you need to restore the user-defined
virtual devices. For instructions, see Restoring user-defined virtual devices manually.