Installing the service access cover on a 7063-CR1 system

Learn how to install the service access cover on a rack-mounted IBM 7063-CR1 Hardware Management Console system.

About this task

Attention: For safety, airflow purposes and thermal performance, the service access cover must be installed and fully seated before you power on the system.

Procedure

  1. Place the rear of the cover on the system. Pivot to front of the cover down until it rests on the system.
  2. Slide the cover forwards until it latches into place as shown in Figure 1.
    Figure 1. Replacing and securing the cover
    Replacing and securing the cover
  3. Replace the two cover screws (2) at the rear of the cover.