Replacing a power supply in the 7063-CR1 system

Learn how to replace power supplies in the IBM 7063-CR1 Hardware Management Console systems.

Procedure

  1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged into a ground jack or connected to an unpainted metal surface. If not, do so now.
  2. Align the power supply with the bay as shown in Figure 1. The fan is on the left; the plug is on the right. Slide the power supply into the system until the latch locks in place.
    Figure 1. Replacing a power supply in the system
    Replacing a power supply in the system.
  3. Reconnect the power cord.
    For instructions, see Connecting the power cords to a 7063-CR1 system.