Removing and replacing the service processor card in the 8408-44E or 8408-E8E
Learn how to remove and replace the service processor card in the 8408-44E or 8408-E8E system.
Removing and replacing the service processor card is a nonconcurrent procedure, which requires the system to be powered off.
The service processor card is installed into slot P1-C5.
Note: The replacement service processor
card has a time-of-day battery card in slot P1-C5-C1, so it is not necessary to remove the existing
card from the failed service processor card.
If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a part in the system. For instructions, see Repairing a part by using the HMC.
If your system is not managed by an HMC, complete the following steps to remove and replace the service processor card:
