Removing and replacing a PCIe adapter in the EMX0 PCIe3 expansion drawer with the power turned on in Linux

Learn to remove and replace a PCIe adapter in the EMX0 PCIe3 expansion drawer with the power turned on in Linux.

If your system is managed by the Hardware Management Console (HMC), use the HMC to repair a part in the system. For instructions, see Repairing a part by using the HMC.

If your system is not managed by an HMC, complete the following steps to remove and replace a PCIe adapter:

  1. Preparing the system to remove and replace a PCIe adapter in the EMX0 PCIe Gen3 I/O expansion drawer with the power turned on in Linux
    Learn about steps you must complete before you remove a PCIe adapter in the EMX0 PCIe3 expansion drawer.
  2. Removing a PCIe adapter from the EMX0 PCIe Gen3 I/O expansion drawer with the power on in Linux
    To remove a PCIe adapter in the EMX0 PCIe3 expansion drawer with the power turned on in Linux, complete the steps in this procedure.
  3. Replacing a PCIe adapter in the PCIe Gen3 I/O expansion drawer with the power turned on in Linux
    To replace a PCIe adapter in the EMX0 PCIe3 expansion drawer with the power turned on in Linux, complete the steps in this procedure.
  4. Preparing the system for operation after removing and replacing a PCIe adapter in the EMX0 PCIe Gen3 I/O expansion drawer with the power turned on in Linux
    Learn to prepare the system for operation after you remove and replace a PCIe adapter in the EMX0 PCIe3 expansion drawer with the power turned on in Linux.
Parent topic: Removing and replacing a PCIe adapter in the EMX0 PCIe Gen3 I/O expansion drawer


Last updated: Tue, May 23, 2017